SusPENT 懸浮劑 Suspending Agent
簡介Introduction
SusPENT懸浮劑用于“控濾失堵漏”，該技術是指當其配制的堵漏漿液進入漏失井段后，在鉆井液液拄壓力和地層壓力所產生的壓差的作用下，漿液從軸向流動轉變?yōu)閺较蛄鲃?，在設置的時間內大量失水，漿液中的固相組份在重力作用下沉積變稠，形成濾餅，繼而壓實，填塞漏失通道，形成段塞，達到減緩漏失的效果；同時鉆井液在所形成的塞面上形成光滑平整的泥餅，起到進一步嚴密封堵漏失通道的效果。
SusPENT suspending agent is utilized for "controlled filtration loss and leak sealing." This technology refers to the process where, after the leak-sealing slurry prepared with SusPENT enters the lost circulation zone in the well, under the pressure differential created by the drilling fluid column pressure and the formation pressure, the slurry transitions from axial flow to radial flow. Within a set time, a significant amount of water is lost from the slurry. The solid components in the slurry deposit and thicken under the influence of gravity, forming a filter cake. This filter cake is subsequently compacted, filling the lost circulation channels and creating a plug, thereby achieving the effect of reducing leakage. Meanwhile, the drilling fluid forms a smooth and even mud cake on the surface of the formed plug, further tightly sealing off the lost circulation channels.
性能及優(yōu)點Performance and advantages
l 推薦加量：1.0~6.0%；
l 液相全濾失時間5min-30min可控，實現(xiàn)控濾失堵漏；
l 可形成密實的濾餅，使裂縫的封堵承壓能力達到20.0MPa以上。
l Recommended dosage: 1.0~6.0%；
l The complete filtration loss time of the liquid phase can be controlled within the range of 5 minutes to 30 minutes, enabling controlled filtration loss and leak sealing;
l It can form a dense filter cake, allowing the pressure-bearing capacity of the sealed fractures to reach over 20.0 MPa.
技術參數Technical Parameters
項目Item | 技術指標Technical Index |
外觀Appearance | 米白色細粉off-white fine powder |
比重Specific Gravity（g/cm3） | 1.30-1.80 |
堵漏漿濾液全濾失時間Complete Filtration Loss Time of The Leak-sealing Slurry Filtrate（min） | 5.0-30.0 |
固體屏障凝膠強度Gel Strength of The Solid Barrier（N） | ≥100.0 |
包裝Packaging
采用三合一復合牛皮紙袋包裝，內襯防水塑料薄膜，可根據用戶需求提供50kg、25kg兩種分裝規(guī)格。
The product is packaged in triple-layer composite kraft paper bags with waterproof plastic film liners, and is available in two packaging specifications: 50kg and 25kg, according to customer requirements.
